Finish: Satin/Reflective

Solvent: Water

Binder Type: Vinyl Acrylic

Recommended Dilution Ratio: If the Metallix paint needs to be let down, add up to 4oz of water per quart or 16oz of water per gallon.

Surface Preparation: Metallix paint should be applied to surfaces that have been primed with an appropriate, high-quality, water base primer that has fully dried. Establishing a base color for the primer similar to the chosen Metallix color will result in better coverage and reflectivity.

Application: Stir well before use. Apply in thin, even, uniform coats, using a high-quality brush, roller, or by spraying*. Do not apply when surface or air temperatures are below 50°F (10°C) or above 90°F (32°C). Follow the Recommended Dilution Ratio above if thinner paint is desired. Note that over-thinning may result in loss of hide.

*Spray equipment specifications:

• Use a Conventional or HLVP cup gun with both air and liquid lines from a pressure pot and compressor
• Needle/Tip: 17/100 or 1.4mm
• PSI: 40
• Do not use an airless spray system

Film Thickness: Coverage: One US gallon of Metallix covers approximately 300 – 400 sq ft (27 – 37 sq m). Coverage varies depending on application technique, dilution, and number of layers.

Avg. Dry Time: Roughly four hours, depending on temperature, air movement, and humidity. If a second coat is desired, allow the first coat to dry for 6-8 hours beforehand.

Clean-up: Clean brushes, rollers, other equipment, and your skin immediately after use with soap and warm water. Close container tightly after use.

Disposal: Dispose of contents/container to an approved waste disposal plant. Consult with local authorities for methods of disposal.

Storage: Store in a cool/dry location at temperatures between 40°F and 90° F. Do not allow paint to freeze or be exposed to temperatures exceeding 120° F for extended periods.

Packaging: Quart (0.946L), 1 Gallon (3.79L).

US VOC: <50 g/l

EU VOC: <12 g/l

CAUTIONS: Not for use on skin. Do not ingest. Use adequate ventilation. KEEP OUT OF REACH OF CHILDREN.

All technical data, recommendations and service are accurate to the best of our knowledge. Rosco assumes no responsibility for the results obtained or damage incurred from use by the buyer in whole or in part since method of application and its use is beyond our control.