Finish: Flat/Matte

Solvent: Water

Binder Type: Vinyl Acrylic

Dilution: May be used straight out of the can or diluted with water, Rosco Clear Acrylic Glaze or a combination of the two. Diluting will reduce the color concentration and create "glaze" effects. Diluting with more than 2 parts water may reduce binder strength. Add Rosco Clear Acrylic Glaze to restore adhesion and flexibility.

Surface Preparation: Surfaces should be clean, dry and free from dirt and grease. Prime porous surfaces, except fabric, using Rosco Tough Prime. If painting a new plaster surface, prime wall with a commercial primer/sealer designed for raw plaster. Then use Rosco Tough Prime as a final preparation.

Application: Stir contents well before each use. Do not shake. Apply by brush, roller or spray gun. Apply in thin, even coats, using a good quality brush or roller. Use overlapping strokes, keeping a wet edge. Change roller direction often to avoid patterns and streaking.

Film Thickness: 2 mil. Dry Film.

Coverage: Approximately 300 sq. ft. per gallon (28 sq. m per 3.79L), depending on substrate, application tool and film thickness.

Avg. Dry Time: At 75°F (24°C), dries to the touch in approximately 30-45 minutes. Can be recoated in 1-2 hours.

Clean-up: Soap and water.

Shelf Life: Minimum shelf life for unopened, sealed paint is approximately 24 months when stored in a temperature controlled location.

Packaging: Quart (0.946L), 1 Gallon (3.79L). *5 Gallon (18.95L) available.

CAUTIONS: Do not apply when surface or air temperatures are below 50°F (10°C). Keep from freezing. Avoid prolonged contact with skin or breathing of spray. Do not take internally. Use adequate ventilation. KEEP OUT OF REACH OF CHILDREN.

All technical data, recommendations and service are accurate to the best of our knowledge. Rosco assumes no responsibility for the results obtained or damage incurred from use by the buyer in whole or in part since method of application and its use is beyond our control.